Filter
Top Products
6 - 10
DRIV
MIDDLE GEAR SERVICE
1 Drive pinion gear
2 Driven pinion gear
3 Reverse gear
4 Middle driven shaft
Shim location
Å = Drive pinion gear shim
ı = Driven pinion gear shim
Ç = Reverse gear shim
Î = Middle driven shaft shim
Å = a - b
ı = c - d - e - f
Ç = d - g - h - i
Î = j + c - e - ı - k - l - 0.25
1 Crankcase (left)
2 Drive pinion gear
3 Driven pinion gear
4 Middle driven shaft
5 Reverse gear
6 Bearing housing
NOTE:
● The gear back lash should be:
0.1 mm ~ 0.2 mm forward
0.1 mm ~ 0.25 mm rear
● Adjust the middle driven shaft in order to
obtain the following thrust free play.
0.1 mm ~ 0.4 mm
Replaced parts Adjust shim
Crankcase ÅıÇÎ
Drive pinion gear Å
Driven pinion gear ıÎ
Reverse gear ÇÎ
Bearing housing ÇÎ
Middle driven shaft Î
6