Filter
Top Products
– 45 –
–+
ELEC
IGNITION SYSTEM
C0NTINUITY
9.Pickup coil resistance
● Disconnect the CDI magneto coupler from
the wire harness.
● Connect the pocket tester (Ω × 100) to the
pickup coil terminal.
Tester (+) lead → White/Green terminal 1
Tester (–) lead → White/Red terminal 2
*
MEETS
SPECIFICATION
● Check the pickup coil for the specified
resistance.
Pickup coil resistance:
189~ 231 Ω at 20˚C (68˚F)
(White/Green – White/Red)
OUT OF SPECIFICATION
Replace the pickup coil/stator assembly.
10.Charging/rotor rotation direction detection
coil resistance
● Disconnect the CDI magneto coupler from
the wire harness.
● Connect the pocket tester (Ω × 100) to the
source coil terminal.
Tester (+) lead → Red terminal 1
Tester (–) lead → White/Blue terminal 2
MEETS
SPECIFICATION
● Check the charging/rotor rotation direction
detection coil for the specified resistance.
Charging/rotor rotation direction
detection coil resistance:
270 ~ 330 Ω at 20˚C (68˚F)
(Red – White/Blue)
*
OUT OF SPECIFICATION
Replace the pickup coil/stator assembly.