Filter
Top Products
hose. When no bubbles appear in the fluid, close
the valve on the slave cylinder. Release the
clutch pedal and then close the valve at the
bleeder unit.
8. Disconnect the bleeder unit, and install the cap
on the slave cylinder bleeder valve.
9. Check the fluid level in the reservoir. If neces-
sary, add or remove clutch hydraulic fluid to bring
the fluid level to the MAX mark. Install the reser-
voir cap.
10. Depress the clutch pedal a few times. There
should be resistance over the full pedal stroke.
11. Check the entire system for leaks. Tighten con-
nections if necessary. Check the fluid level in the
reservoir again.
12. Remove the chocks from the tires.
Clutch25
Acterra Maintenance Manual, September 200225/4