Filter
Top Products
IMPORTANT: After performing all operations listed in
this table, perform all daily, weekly, and monthly
maintenance operations listed in the "Pretrip and
Post-Trip Inspections and Maintenance" chapter of
the
Acterra
®
Driver’s Manual
. Also, perform all M1
Maintenance Interval Operations at the M2 Mainte-
nance Interval.
NOTE: Maintenance operations appearing in italics in
this table are for noise emission control components.
Numbers in this table are maintenance operation ref-
erence numbers matching those in the text of this
manual. The M2 Maintenance consists of all M1 In-
terval Operations plus the other operations listed
below.
M2 Maintenance Interval Operations
Maint.
Oper. No.
M2 Maintenance Interval Operations
00–10 Perform All M1 Operations
00–16 Lubrication and Fluid Level Check:
• Two-Speed-Axle Shift Unit Oil Level Checking
• Camshaft Bracket Bushing Lubricating
• Air Reservoir Automatic Drain Valve Disassembly, Cleaning, Inspect-
ing, and Lubricating, Bendix DV–2
• Bosch Rail-Slide Hydraulic Brake Caliper Lubricating
• Steering Driveline Lubricating
13–01 Air Compressor Inspecting, Bendix
20–01 Radiator Cap Checking
20–03
Fan Clutch Checking
26–03 Allison, Eaton/Fuller, and Meritor Transmission Breather Checking
42–11 Automatic Slack Adjuster Inspecting, Meritor
49–01
Exhaust System Inspecting
83–02 HVAC Air Filter Replacing
*
*
Replace the HVAC filter every 6 months regardless of mileage.
General Information 00
M2 Maintenance Interval Operations Table: 00–11
Acterra Maintenance Manual, January 2007 00/17