3-40
CHK
ADJ
5
CHECKING AND ADJUSTING THE STEERING HEAD
EAS00148
CHECKING AND ADJUSTING THE STEER-
ING HEAD
1. Stand the scooter on a level surface.
WARNING
Securely support the scooter so that there
is no danger of it falling over.
TIP
Place the scooter on a suitable stand so that
the front wheel is elevated.
2. Check:
8steering head
Grasp the bottom of the front fork legs and
gently rock the front fork.
Binding/looseness J Adjust the steering
head.
3. Remove:
8leg shield 1
Refer to “COVER AND PANEL”.
4. Adjust:
8steering head
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the upper ring nut 1, lock washer
2, the center ring nut 3 and the rubber
washer 4.
b. Loosen the lower ring nut 5 and then tighten
it to specification with the ring nut wrench
6.
TIP
Set the torque wrench at a right angle to the ring
nut wrench.
Ring nut wrench
90890-01403 (YU-A9472)
Downloaded from www.ScooterTime.net