1-9
GEN
INFO
Tool NO.
Tool name / Function Illustration
90890-01085 (M8)
YU-01083-2
90890-01084
YU-01083-3
90890-01235
YU-01235
90890-01268
YU-01268
90890-01304
YU-01304
90890-01337
YM-33285
90890-01311
YM-08035-A
90890-01326
YM-01326
90890-01294
YM-01300-1
90890-01348
YM-01348
Slide hammer bolt (8mm) 1
Weight 2
These tools are needed to remove the cam-
shaft.
Rotor holding tool
This tool is used to hold the primary fixed
sheave and secondary sheave assembly.
Ring nut wrench
This tool is used to loosen and tighten the
exhaust and steering ring nut.
Piston pin puller set
This tool is used to remove the piston pin.
Clutch spring holder
These tool are used for removing the nut with
holding the compression spring.
Valve adjusting tool
This tool is necessary for adjusting valve
clearance.
T-handle 1
Damper rod holder 2
These tools are used to hold the damper rod
when removing or installing the damper rod.
Lock nut wrench
This tool is used when removing or install-
ing the secondary sheave nut.
SPECIAL TOOLS
1
2
1
2
EAS00027
SPECIAL TOOLS
The following special tools are necessary for complete and accurate tune-up and assembly. Use
only the appropriate special tools as this will help prevent damage caused by the use of inappropri-
ate tools or improvised techniques. Special tools, part numbers or both may differ depending on the
country.
When placing an order, refer to the list provided below to avoid any mistakes.
TIP
8 For U.S.A. and Canada, use part number starting with "YM-", "YU-", or "ACC-".
8 For others, use part number starting with "90890-".
41
46
Downloaded from www.ScooterTime.net