Filter
Top Products
CHAS
4-28
2
1
3
FRONT BRAKE
3. Install:
8copper washers 1
New
8brake hose 2
8union bolt 3
26Nm (2.6m • kgf, 18.8ft • lbf)
NOTICE
When installing the brake hose onto the
brake master cylinder, make sure the brake
hose touch the projection
aa
aa
a on the brake
master cylinder.
WARNING
Proper brake hose routing is essential to
insure safe scooter operation. Refer to
“CABLE ROUTING” in chapter 2.
TIP
8 While holding the brake hose, tighten the
union bolt as shown.
8 Turn the handlebar to the left and right to
make sure the brake hose does not touch
other parts (e.g., wire harness, cables,
leads). Correct if necessary.
4. Fill:
8brake fluid reservoir
(with the specified amount of the recom-
mended brake fluid)
Recommended brake fluid
DOT 4
WARNING
88
88
8 Use only the designated brake fluid.
Other brake fluids may cause the rub-
ber seals to deteriorate, causing leakage
and poor brake performance.
88
88
8 Refill with the same type of brake fluid
that is already in the system. Mixing
brake fluids may result in a harmful
chemical reaction, leading to poor brake
performance.
88
88
8 When refilling, be careful that water does
not enter the brake fluid reservoir. Wa-
ter will significantly lower the boiling
point of the brake fluid and could cause
vapor lock.
T
R
.
.
Downloaded from www.ScooterTime.net