Filter
Top Products
2-31
SPEC
CABLE ROUTING
1 Rear brake cable
2 Speedometer
3 Front master cylinder
4 Brush guard (right)
5 Turn signal light (right)
6 Throttle cable assembly
7 Speedometer cable
8 Turn signal light (left)
9 Brush guard (left)
0 Handlebar bracket
q Clamp (90464-12812)
w Bracket
e Turn signal light lead (right)
r Right handlebar switch lead
t Front brake light switch lead
y Speedometer lead
u Rear brake light switch lead
i Left lever holder lead
o Turn signal light lead (left)
p Brake hose
A Fasten the right handlebar switch lead, front
brake light switch lead and right turn signal
light lead to the handlebar.
B Upper screw tighten first.
C Torque: 4Nm (0.4m • kgf, 2.9ft • lbf).
D Band holds the wires and hoses with finger
clearance, and cut off the surplus until 5mm
left. Band is above the pin of handlebar
bracket.
E When assemble the lower handlebar holder,
the position point is in the front.
B
3
4
C
q
0
E
1
o
i
u
y
7
t
r
e
p
6
D
w
1
2
5
6
7
8
9
A
E VIEW
E
Downloaded from www.ScooterTime.net