1-8
GEN
INFO
CHECKING THE CONNECTIONS
EAS00026
CHECKING THE CONNECTIONS
Check the leads, couplers, and connectors for
stains, rust, moisture, etc.
1. Disconnect:
8lead
8coupler
8connector
2. Check:
8lead
8coupler
8connector
Moisture J Dry with an air blower.
Rust/stains J Connect and disconnect
several times.
3. Check:
8all connections
Loose connection J Connect properly.
TIP
If the pin 1 on the terminal is flattened, bend it
up.
4. Connect:
8lead
8coupler
8connector
TIP
Make sure all connections are tight.
5. Check:
8continuity
(with the pocket tester)
Pocket tester
90890-03112 (YU-03112-C)
TIP
8 If there is no continuity, clean the terminals.
8 When checking the wire harness, perform
steps (1) to (3).
8 As a quick remedy, use a contact revitalizer
available at most part stores.
Downloaded from www.ScooterTime.net