Filter
Top Products
3-34
CHK
ADJ
CHECKING THE CANISTER AND ROLL OVER VALVE
7. Check:
8roll over valve
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the roll over valve.
b. Put roll over valve with the vertical angle.
c. Connect the hose to direction a and blow
air in the hose.
Unobstructed J Normal.
Obstruction J Replace.
d. Put roll over valve with the horizontal angle.
e. Connect the hose to direction a and blow
air in the hose.
Unobstructed J Replace.
Obstruction J Normal.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
8. Install:
8roll over valve
TIP
Roll over valve should be installed on the frame
with the vertical angle. If roll over valve to slope
or the horizontal (more than about 45 degrees)
installation, will make the scooter unable to start.
9. Install:
8trunk
8seat
Refer to “COVER AND PANEL”.
Downloaded from www.ScooterTime.net