Filter
Top Products
ENG
5-44
1
2
BELT DRIVE
TIP
While holding the clutch carrier with the rotor
holding tool 2, loosen the clutch carrier nut one
full turn with the locknut wrench 3.
Rotor holding tool
90890-01235 (YU-01235)
Locknut wrench
90890-01348 (YM-01348)
3. Remove:
8secondary sheave 1
8V-belt 2
TIP
Remove the V-belt and secondary sheave from
the primary sheave side.
CHECKING THE CLUTCH SHOES
The following procedure applies to all of the clutch
shoes.
1. Check:
8clutch shoe
Damage/wear J Replace the clutch
shoes and springs as a set.
Glazed areas JSand with coarse sand-
paper.
EAS00319
DISASSEMBLING THE SECONDARY
SHEAVE
1. Remove:
8clutch carrier nut 1
TIP
Install the clutch spring holder 2 and clutch
spring holder arm 3 onto the secondary sheave
as shown. Then, compress the spring, and re-
move the clutch carrier nut.
Clutch spring holder
90890-01337 (YM-33285)
Downloaded from www.ScooterTime.net