Filter
Top Products
CHAS
4-16
1
T
R
.
.
REAR WHEEL AND REAR BRAKE
TIP
Lubricate the brake camshaft and O-rings with
lithium-soap-based grease.
WARNING
After installing the brake camshaft and O-
rings, remove any excess grease.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Install the brake camshaft so its punch mark
a is positioned as shown.
b. Align the projection b on the brake cam-
shaft lever with the notch in the brake shoe
camshaft.
c. Check that the brake shoes are properly
positioned.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
2. Tighten:
8brake camshaft lever
10Nm(1.0m • kgf, 7.2ft • lbf)
3. Install:
8brake shoe kit 1
8tension springs
NOTICE
88
88
8 Do not put lubricating oil on the brake
lining.
88
88
8 Change the tension spring at the same
time of changing the brake shoe.
88
88
8 Refer to the direction in the illustration
when assembling the brake shoe and
spring.
88
88
8 Refer to the illustration with regards to
the assembly direction of tension spring,
and do not let the spring hook and coil
to be damaged by the pliers.
Downloaded from www.ScooterTime.net