3-39
CHK
ADJ
BLEEDING THE HYDRAULIC BRAKE SYSTEM
TIP
Loosening the bleed screw will release the pres-
sure and cause the brake lever to contact the
throttle grip.
h. Tighten the bleed screw and then release
the brake lever.
i. Repeat steps (e) to (h) until all of the air
bubbles have disappeared from the brake
fluid in the plastic hose.
j. Tighten the bleed screw to specification.
Bleed screw
6Nm (0.6m • kgf, 4.3ft • lbf)
k. Fill the brake fluid reservoir to the proper
level with the recommended brake fluid.
Refer to “CHECKING THE BRAKE
FLUID LEVEL”.
WARNING
After bleeding the hydraulic brake system,
check the brake operation.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3. Install:
8brake master cylinder reservoir cap
1.6Nm (0.16m • kgf, 1.5ft • lbf)
T
R
.
.
T
R
.
.
Downloaded from www.ScooterTime.net