7-6
-+
ELEC
EAS00733
CHECKING THE BULBS AND BULB
SOCKETS
Check each bulb and bulb socket for damage or
wear, proper connections, and also for continu-
ity between the terminals.
Damage/wear J Repair or replace the
bulb, bulb socket or both.
Improperly connected J Properly con-
nect.
No continuity J Repair or replace the bulb,
bulb socket or both.
TYPES OF BULBS
The bulbs used on this scooter are shown in the
illustration on the left.
8Bulbs A and B are used for the head-
lights and usually use a bulb holder that
must be detached before removing the
bulb. The majority of these types of bulbs
can be removed from their respective
socket by turning them counterclockwise.
8Bulbs C is used for turn signal and tail/
brake lights and can be removed from the
socket by pushing and turning the bulb
counterclockwise.
8Bulbs D and E are used for meter and
indicator lights and can be removed from
their respective socket by carefully pull-
ing them out.
CHECKING THE CONDITION OF THE BULBS
The following procedure applies to all of the
bulbs.
1. Remove:
8bulb
WARNING
Since the headlight bulb gets extremely hot,
keep flammable products and your hands
away from the bulb until it has cooled down.
A
B
C
D
E
CHECKING THE BULBS AND BULB SOCKETS
Downloaded from www.ScooterTime.net