5B.35
Section 5B
EFI Fuel System
5B
Long Pause
Short Pauses
Code 32
3
2
Code 61
1
6
Long Pause
Light remains on at end of transmission
1. Diagnostic display initiated through ignition key sequencing.
2.
Figure 5B-43.
After the problem has been corrected, the fault codes may be cleared as follows.
1. Disconnect the negative (-) battery cable from battery terminal, or remove the main fuse for the ECU for
approximately 1 minute.
2. Reconnect the cable and tighten securely, or reinstall the main fuse. Start the engine and allow it to run for
several minutes. The MIL should remain off if the problem was corrected, and the fault codes should not
reappear (codes 31, 32, 33, and 34 may require 10-15 minutes of running to reappear).
The following chart lists the fault codes, what they correspond to, and what the visual indications will be. Following
the chart is a list of the individual codes with an explanation of what triggers them, what symptoms might be
expected, and the probable causes.
Diagnostic Code Summary
Example of Diagnostic Display
Long Pause
3.
4.
5.
6.
7.
knilB
edoC
2DBO
edoC-P
elbacilppA
"niP23":ot
)1.1ESM(
-tsyS/UCE
ylnOme
noitpircseDeruliaFronoitcennoC
"niP53"
)7.1AM(
desaC-lateM
metsyS/UCE
"niP42"
)0.1ESM(
desaC-citsalP
metsyS/UCE
"niP23"
)1.1ESM(
desaC-citsalP
metsyS/UCE
etoN
-- langiSMPRoNYYY
125330PnoitazinorhcnySfossoLYYY
220210PelbisualpmIlangiS-SPTNNN2
222210PdnuorGottiucriCtrohSronepO-SPTYYY
223210PyrettaBottiucriCtrohS-SPTYYY
321060PUCEevitcefeDYYY
42rosneSdeepSenignEYYY9
134710PnaeLootmetsySYYY6
cont. on next page