Filter
Top Products
7 Release the spring clips and withdraw the
bulb (see illustrations).
8 Fit the new bulb with the locating tab
uppermost.
Front parking lights
9 Pull the bulbholder from the rear of the
headlight then depress and twist the bulb to
remove it (see illustration).
Front direction indicator
10 Turn the bulbholder anti-clockwise and
withdraw it from the rear of the light (see
illustration).
11 Depress and twist the bulb to remove it
(see illustration).
Front direction indicator side repeater
12 On early models, reach up behind the
front wing, squeeze the plastic tabs together
and push out the light. On later models, turn
the light anti-clockwise and withdraw it from
the front wing (see illustration).
13 Disconnect the wiring, remove the end
cap, and extract the bulb:
14 When refitting the early type, position the
light so that the location peg enters the hole in
the front wing.
Front driving light (GTI models)
15 Remove the two lens surround retaining
screws and withdraw the surround, lens and
reflector (see illustration).
16 Release the spring clips and remove the
bulb assembly (see illustration).
17 Detach the bulb feed wire at the
connector.
Rear light cluster bulbs
18 Remove the lens upper retaining screws
then tilt the lens back and release it from the
lower tabs (see illustrations).
19 Depress and twist the bulb to remove it
(see illustration).
Rear foglight
20 Remove the screws and withdraw the lens
(see illustration).
12•10 Body electrical system
8.7a . . . release the spring clips . . . 8.7b . . . and withdraw the headlight bulb 8.9 Removing the front parking light
bulbholder
8.16 . . . then release the spring clips and
remove the bulb assembly
8.18a Remove the rear light cluster
screws . . .
8.18b . . . and release the lens from the
tabs
8.11 . . . and extract the bulb
8.10 Remove the front direction indicator
light bulbholder . . .
8.12 Removing the front direction
indicator side repeater on later models
8.15 On GTI models, remove the driving
light lens surround, lens and reflector . . .