Filter
Top Products
66 SMART-MR10/15 User Manual Rev 5
Chapter 4 PC Utilities
6. When the Authorization Code dialog opens, see Figure 24, enter the auth code then click OK.
Figure 24: Authorization Code Dialog
7. The receiver should finish downloading and reset. The process is complete when “Done.” is dis-
played in the main display area, see Figure 25.
Figure 25: Upgrade Process Complete
8. Close WinLoad.
This completes the update/upgrade procedure.
4.4.2 Upgrading Using the AUTH Command
The AUTH command authorizes the enabling (unlocking) of model features. Use this command when
upgrading to a new OEMV family model that is available with the same firmware version as your
current model. This command only functions in conjunction with a valid auth-code assigned by
Customer Support.
The upgrade can be performed directly through the Connect command line, or from any other
communications program. The procedure is as follows:
1) Power-up the OEMV family receiver and establish communications over a serial port (see
Chapter 3, Operation on Page 46)
2) Issue the LOG VERSION command to verify the current model, firmware version, and serial
number.
3) Issue the AUTH command, followed by the auth-code and model type. The syntax is as follows:
Syntax:
auth auth-code
where auth is a command that enables model upgrades, and auth-code is the upgrade authorization
code, expressed as hhhh,hhhh,hhhh,hhhh,hhhh,model#
where the h characters are in ASCII hexadecimal code, and the model# is in ASCII text.