Filter
Top Products
Installation Chapter 2
SMART-MR10/15 User Manual Rev 5 37
2.3.2 Status Indicators
LED indicators on the SMART-MR10/15 provide receiver status information:
•Power
• Position Status
• Position Type
Table 7 and Table 8 show the meaning of the LED states in the expected sequence after power is
applied.
Table 7: SMART-10 LED Status Indicators
Flashing means that the LED is turning on and off at a 1 Hz rate - 0.5 seconds on and 0.5 seconds off.
Red
Yellow
Green
Condition
Off Off Off Power is not available. (Red indicator may also not be lit if a boot
failure has occurred.)
On Off Off Power available but no satellites are being tracked
On Flashing Off Tracking at least one satellite but not a valid position
On On Off Position valid in basic autonomous mode
On On Flashing SBAS tracking, but not enough data for enhanced solution.
On On On
Position valid in an enhanced accuracy mode
a
(WAAS/EGNOS/MSAS/DGPS, OmniSTAR VBS/XP/HP, or RTK)
a. When acting as a reference receiver, all lights on solid indicates a good fixed position.
On Flashing Flashing
Fixed position with bad integrity
a