Filter
Top Products
44 SMART-MR10/15 User Manual Rev 5
Chapter 2 Installation
3. Remove the SIM cover (shown in Figure 11) by loosening the two screws that secure the cover.
4. Install the SIM following the orientation shown on the SIM cover (notch up and in, as shown in
Figure 12). The SIM connector is a push -in/push-out type. If the SIM is correctly installed, its
outside edge will be essentially flush with the surrounding enclosure metal surface, as shown in
Figure 13.
5. To register with the cellular network, issue the following commands with data provided by the
carrier:
cellset apn <apn_name> {always required}
cellset user <user_name> {if provided by carrier}
cellset password <password> {if provided by carrier}
When you are replacing the SIM cover, make sure it is installed straight or you may
inadvertently cause the SIM card to eject.
To remove the SIM push it in slightly and it should then be partially ejected by the SIM
holder, as shown in Figure 14.
The modem will not work if the SIM is in the partially ejected “ready for removal”
position.Ensure the SIM door is properly aligned, then secure it in place.
Figure 11: SIM Cover Figure 12: SIM Being Installed
Figure 13: SIM Correctly Installed Figure 14: SIM Ready for Removal
Secure the SIM cover to the base using a flat-head screwdriver. Screws should be torqued
to 4-6 in-lb, to ensure the unit does not leak.