Filter
Top Products
PC Utilities Chapter 4
SMART-MR10/15 User Manual Rev 5 65
Once you have selected your file and clicked Open, the name of the file appears in the main WinLoad
display area and in the title bar, see Figure 21.
Figure 21: Open File in WinLoad
Communications Settings
To set the communications port and baud rate, select COM Settings from the Settings menu. Choose
the port on your PC from the Com Port drop-down list and the baud rate from the Download Baudrate
drop-down list. The baud rate should be as high as possible (the default of 115200 is preferred).
Figure 22: COM Port Setup
Downloading firmware
To download firmware follow these steps:
1. Set up the communications port as described in Communications Settings above.
2. Select the file to download, see Open a File to Download on page 64.
3. Make sure the file path and file name are displayed in main display area, see Figure 21, Open File
in WinLoad on page 65.
4. Click Write Flash to download the firmware.
5. Power down and then power up the receiver when “Searching for card” appears in the main dis-
play, see Figure 23.
Figure 23: Searching for Card