Filter
Top Products
11.16
Section 11
Reassembly
Install Blower Housing and Outer Baffles
NOTE: Do not completely tighten screws until all
items are installed to allow shifting for hole
alignment.
1. Pull the wire harness and spark plug leads out
through the appropriate openings in the
shrouding. See Figures 11-57 and 11-58.
Figure 11-57. Wires on Starter Side of Engine.
Figure 11-55. Installing Inner Baffles.
Figure 11-54. Installing Screws (Locations 3 and 4).
4. Install the inner baffles using the remaining two
hex flange screws (see Figures 11-55 and 11-56)
and finger tighten. Do not torque the screws at
this time; they will be tightened after the blower
housing and outer baffles are installed.
Figure 11-56. Finger Tighten Two Remaining Cover
Screws.
Figure 11-58. Wires on Oil Filter Side of Engine.
2. Slide the blower housing into position over the
front edge of the inner baffles. See Figure 11-59.
Start a few of the screws to hold it in place.