Filter
Top Products
Garmin G1000 Pilot’s Guide for the Beechcraft A36/G36
190-00595-01 Rev. B60
FLIGHT INSTRUMENTS
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
TURN RATE INDICATOR
The Turn Rate Indicator is located directly above the rotating compass card. Tick marks to the left and right
of the lubber line denote half-standard and standard turn rates. A magenta Turn Rate Trend Vector shows the
current turn rate. The end of the trend vector gives the heading predicted in 6 seconds, based on the present
turn rate. A standard-rate turn is shown on the indicator by the trend vector stopping at the standard turn
rate tick mark, corresponding to a predicted heading of 18˚ from the current heading. At rates greater than 4
deg/sec, an arrowhead appears at the end of the magenta trend vector and the prediction is no longer valid.
Standard
Turn Rate
Half Standard
Turn Rate
Arrow Shown
for Turn Rate
> 4 Degrees
per Second
Figure 2-21 Turn Rate Indicator and Trend Vector
BEARING POINTERS AND INFORMATION WINDOWS
NOTE: When the Arc HSI is displayed, the Bearing Information windows and pointers are disabled.
Two bearing pointers and associated information can be displayed on the HSI for NAV and GPS sources.
The pointers are light blue and are single- (BRG1) or double-lined (BRG2); an icon is shown in the respective
information window to indicate the pointer type. The bearing pointers never override the CDI and are
visually separated from the CDI by a white ring (shown when bearing pointers are selected but not necessarily
visible due to data unavailability).
Figure 2-22 HSI with Bearing and DME Information
Bearing 2 Information Window
No
Waypoint
Selected
Pointer
Icon
Bearing
Source
Bearing 1 Information Window
Pointer
Icon
Distance to
Bearing Source
Bearing
Source
Bearing 2
Pointer
Bearing 1
Pointer
Frequency
Tuning Mode
Distance
Station
Identifier
DME Information Window
(optional)