Filter
Top Products
190-00595-01 Rev. B
Garmin G1000 Pilot’s Guide for the Beechcraft A36/G36
11
SYSTEM OVERVIEW
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& cNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
6
COM3
– Not used in Beechcraft A36/G36 aircraft.
7
COM 1/2
–
Split COM Key. Allows simultaneous transmission on COM1 and COM2 by the pilot and copilot.
8
TEL
– Not used in Beechcraft A36/G36 aircraft.
9
PA
– Not used in Beechcraft A36/G36 aircraft
.
10
SPKR
– Selects and deselects the cabin speaker. COM and NAV receiver audio can be heard on the
speaker.
11
MKR/MUTE
– Selects marker beacon receiver audio. Mutes the currently received marker beacon receiver
audio. Unmutes automatically when new marker beacon audio is received. Also, stops play of recorded
COM audio.
12
HI SENS
– Press to increase marker beacon receiver sensitivity. Press again to return to low sensitivity.
13
DME
– Pressing turns optional DME audio on or off.
14
NAV1
– When selected, audio from the #1 NAV receiver can be heard.
15
ADF
– Not used in Beechcraft A36/G36 aircraft.
16
NAV2
– When selected, audio from the #2 NAV receiver can be heard.
17
AUX
– Not used in Beechcraft A36/G36 aircraft.
18
MAN SQ
– Enables manual squelch for the intercom. When the intercom is active, press the PILOT Knob
to illuminate SQ. Turn the PILOT/PASS Knobs to adjust squelch.
19
PLAY
– Press once to play the last recorded COM audio. Press again while audio is playing and the
previous block of recorded audio is played. Each subsequent press plays each previously recorded block.
Pressing the
MKR/MUTE
Key during play of a memory block stops play.
20
PILOT
– Selects and deselects the pilot intercom isolation.
21
COPLT
– Selects and deselects the copilot intercom isolation.
22
PILOT Knob
– Press to switch between volume and squelch control as indicated by illumination of VOL
or SQ. Turn to adjust intercom volume or squelch. The MAN SQ Key must be selected to allow squelch
adjustment.
23
PASS Knob
– Turn to adjust Copilot/Passenger intercom volume or squelch. The MAN SQ Key must be
selected to allow squelch adjustment.
24
DISPLAY BACKUP Button
– Manually selects Reversionary Mode.