Filter
Top Products
QUICK OPERATION
Startup
For unpacking and
installation instructions,
see section 1 on page 2 in
this manual
„ Turn on the dc breaker, labeled “DC OUTPUT”.
„ Turn on the ac breaker, labeled “AC INPUT”.
Changing between Float and Equalize Modes
To learn how to use the
equalize timers, see
sections 2.2.4 on page 27
and 2.3.3 on page 32
„ Press the
key to toggle from Float mode to
Equalize mode. Press again to toggle back to
Float. The green or yellow indicator identifies
the current mode.
For details on setting
parameters, see section
2.3 starting on page 30
Setting
Float Voltage
Equalize Voltage
Equalize Timer
High DC Voltage
Low DC Voltage
If you don’t press any key
for 25 seconds, the AT10.1
resumes normal operation
automatically
„ Press the
key. The DC VOLTS and
FLOAT indicators light, and the digital display
flashes the present float voltage setting.
„ Press the
or key until the digital
display indicates the desired float voltage.
„ Press the
key to save the new setting
internally.
„ The EDIT sequence advances to the equalize
voltage as shown by the front panel indicators.
Repeat the above steps until you have set all
parameters.
JA5011-01 -