Filter
Top Products
OPERATING THE AT10.1
31
2.3.2. Setting the Float and Equalize voltages
• Press the EDIT/ENTER key.
The FLOAT and DC VOLTS indicators light, and the display flashes the
present value of the float voltage. Press and release the UP or DOWN key to
increase or decrease the value in the display by one count, or press and
hold the UP or DOWN key to scroll the value in the display upward or
downward. When the display shows the float voltage you want to set,
release the UP or DOWN key. If you go past the voltage you want, press the
UP or DOWN key again to reach the voltage you want to set.
• Press the EDIT/ENTER key. The new float voltage setting is saved
internally.
The EQLZ and DC VOLTS indicators light, and the display flashes the
present value of the equalize voltage. Press and release the UP or DOWN
key to increase or decrease the value in the display by one count, or press
and hold the UP or DOWN key to scroll the value in the display upward or
downward. When the display shows the equalize voltage you want to set,
release the UP or DOWN key. If you go past the voltage you want, press the
UP or DOWN key again to reach the voltage you want to set.
• Press the EDIT/ENTER key. The new equalize voltage setting is saved
internally.
If you want to adjust the equalize timer duration, skip to section 2.3.3.
OR
If you want to exit the Edit mode now, press the EDIT/ENTER key four more
times until the charger returns to normal operation.
Edit mode ends automatically if you don't press any front panel key within
25 seconds, and any change you made to the last setting is not saved.