Filter
Top Products
Chapter 2 Operating Instructions
ATCA-C110/1G Installation and Use Manual
27
REVIEW COPY
Debug Support
The debug mechanisms supported on ATCA-C110/1G include:
■ Debug connectors for IPMC
A serial interface for debug will be provided for each ATMega controller. The debug
connectors are located on the ARTM-C110 serial ports COM 1 to COM 4. Refer to the
ARTM-C110 Installation and Use manual as listed in Appendix D, Related Documentation
for details.
■ JTAG Interfaces
There would be two separate JTAG Interfaces on ATCA-C110/1G.
The JTAG chain from the main board is extended to the FIM board through the FIM
connector and is connected to the main devices on the FIM. The JTAG chain is also
extended to the ARTM-C110 through the Zone 3 interface and is connected to the main
devices on the ARTM-C110.