Filter
Top Products
Chapter 1 ATCA-C110/1G Baseboard Preparation and Installation
ATCA-C110/1G Installation and Use Manual
15
REVIEW COPY
Rear Transition Modules
At the time of writing this manual the ACC/ARTM-C110 Rear Transition Module was available
for the blade. For further information, refer to the ACC/ARTM-C110 Installation and Use
manual.
The RTM provides the following interfaces:
■ Debug Serial port for the IPMI Controllers onboard the ATCA-C110/1G
■ Debug Serial port from the Control Processor
■ Ethernet port for the 10/100 port from the Control Processor
■ Four Gigabit Ethernet ports from the FIM
■ CX4 connector for XAUI interface from Ethernet Switch on the FIM
■ Debug USB connector for the interface from AMC Bay 4
■ RJ45 connector for Telecom clock interface
■ JTAG header for programming
■ SPI Programming Interface for IPMI Programming
■ IPMI Interface
Note
■ You must install the ARTM-C110 before the ATCA-C110/1G carrier board is installed.
■ Refer to the ARTM-C110 Installation and Use manual for the RTM installation
procedure.
■ Check the documentation of the system where you operate the blade and the RTM for
any restrictions that may apply to the blade or the RTM.
■ No hot-swap is supported for the RTMs.