Filter
Top Products
ATCA-C110/1G Installation and Use Manual
About This Manual
xviii
REVIEW COPY
Order Numbers
The table below is an excerpt from the blade’s ordering information. Ask your local Motorola
representative for the current ordering information.
The table below is an excerpt from the blade’s accessories ordering information. Ask your local
Motorola representative for the current ordering information.
Overview of Contents
This manual is divided into the following chapters and appendices.
Chapter 1, ATCA-C110/1G Baseboard Preparation and Installation, includes instructions
and diagrams for hardware preparation and installation and removal procedures.
Chapter 2, Operating Instructions, provides a description of basic operational
characteristics of the ATCA-C110/1G including system initialization sequence, hot swap
support, sources of reset, and the debug support.
Chapter 3, U-Boot Firmware Overview, gives a brief overview of U-Boot boot loader and
host system set up.
Chapter 4, Functional Description, describes the ATCA-C110/1G on a block diagram level.
It provides an explanation of the various components and the functional characteristics of
the board.
Chapter 5, Controls, Indicators and Connector Pin Assignments, summarizes the LEDs
and pin assignments provided on the ATCA-C110/1G baseboard.
Chapter 6, Memory Map and Registers, provides a description of memory maps and
programming information including register reference, and memory structure.
Appendix A, Troubleshooting, provides a hint list for detecting possible errors which could
be mechanical in nature or which could occur after power on, during boot-up or during
board operation.
Appendix B, Specifications, lists the general specifications and compliance for
ATCA-C110/1G boards.
Table 1. Ordering Information
Order Number Variant Name Description
121871 ATCA-C110/1G-1GB-833 AMC carrier board along with 1G FIM
Table 2. Accessories Ordering Information
Order Number Accessory Description
122375 ACC/ARTM-C110/1G Rear transition module for ATCA-C110/1G.