Filter
Top Products
ATCA-C110/1G Installation and Use Manual
Chapter 1 ATCA-C110/1G Baseboard Preparation and Installation
16
REVIEW COPY
Switch Settings
The blade provides the configuration switch SW1. The switch provides AMC bay selection in the
JTAG chain. The board is delivered with the white switch set to the default OFF position. Refer
to Table 1-2 on page 16 for default switch settings of SW1.
Before You Install or Remove an AdvancedTCA Blade
Blades may be damaged if improperly installed or handled. Please read and follow the
guidelines in this section to protect your equipment.
Figure 1-11. Switch Settings
O
N
1
S
W1
Table 1-2. Default Switch Settings for SW1
SW0 SW1 Description
On On AMC Bay 1 on the JTAG chain
Off On AMC Bay 2 on the JTAG chain
On Off AMC Bay 3 on the JTAG chain
Off Off AMC Bay 4 on the JTAG chain