Yamaha YZF-R1PC Utility Trailer User Manual


 
2 - 38
SPEC
CABLE ROUTING
Ú Route under the wire harness
to the assembling point !.
Û Insert the holding clamp of the
wire harness to the frame.
Ü Fasten the wire harness with
the clamp inserted to the
frame.
Ý Route the radiator fan motor
lead above the wire harness.
Þ Assembling point #
Beneath the under bracket
ß Route the handlebar switch
lead and main switch leads
along the groove of the guide-
air.
À To cord headlight
Á Route the starter motor lead
through the clamp inserted to
the box battery.
Route the starter motor lead
through the clamp inserted to
the box battery.
Clamp the lead as being in
parallel along the fender.
Make sure to clamp three
leads.
Fasten the wire harness with
the clamp inserted to the
hole of the box battery.
Routing position of each lead
except the wire harness is
not regulated in the clamp.
Branch from the main har-
ness
Assembling point $
Beneath the under bracket,
below the cover steering
Throttle cable should not be
placed on the rib of guide-air.
To coolant temperature sen-
sor
Do not pinch the handlebar
switch lead when assem-
bling the ignition coil plate.
Pass the filter of throttle body
through the notch of the rub-
ber baffle and release it
under the ignition coil plate.
AA
AB
AC
AD
AE
AF
AG
AH
AI
AJ