2 - 35
SPEC
CABLE ROUTING
EAS00035
CABLE ROUTING
1
Headlight drain plug
È
Make sure to securely insert
the coupler and boot.
É
The headlight lead can be
routed by either of the head-
light or the boss. Do not catch
the headlight lead when
assembling the front cowling.
Ê
Do not make the lead stretch
too much.
Ë
Secure the junction of the cord
headlight at the place of white
tape.
Ì
Secure the junction of head-
light lead (including the head-
light leads and position lamp
leads) at the place of white
tape with the clamp behind the
pawl of headlight body.
Í
To turn signal light
Î
To main harness
Ï
Route the junction of the head-
light, position lamp and turn
signal light leads through the
pawl on the headlight body.
(Pay attention to the direction.)
Ð
Insert the headlight relay to the
rib of the headlight body. (No
special roder is specified for
right and left.)
Ñ
Route the headlight lead
behind the cap of headlight
breather hole. (It can be routed
below, but should not be in
front of the cap.)
Ò
To the auxiliary light lead
Ó
To meter assembly
Ô
To headlight relay