4 - 60
CHAS
HANDLEBARS
6. Install:
• left handlebar switch 1
NOTE:
_
Align the projection a on the left handlebar
switch with the hole b in the left handlebar.
7. Install:
• handlebar grip
▼▼▼▼ ▼ ▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Apply a thin coat of rubber adhesive onto
the end of the left handlebar.
b. Slide the handlebar grip over the end of the
left handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
WARNING
@
Do not touch the handlebar grip until the
rubber adhesive has fully dried.
▲▲▲▲ ▲ ▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
8. Adjust:
• clutch cable free play
Refer to “ADJUSTING THE CLUTCH
CABLE FREE PLAY” in chapter 3.
9. Adjust:
• throttle cable free play
Refer to “ADJUSTING THE THROTTLE
CABLE FREE PLAY” in chapter 3.
Clutch cable free play
(at the end of the clutch lever)
10 ~ 15 mm (0.39 ~ 0.59 in)
Throttle cable free play
(at the flange of the throttle grip)
3 ~ 5 mm (0.12 ~ 0.20 in)