Filter
Top Products
1 - 21
GEN
INFO
FEATURES
Display brightness and engine speed indi-
cator light control mode
This mode cycles through five control func-
tions, allowing you to make the following set-
tings in the order listed below.
1. Display brightness: This function allows you
to adjust the brightness of the multi-function
display to suit the outside lighting condi-
tions.
2. Engine speed indicator light activity: This
function allows you to choose whether or
not the indicator light should be activated
and whether it should blink or stay on when
activated.
3. Engine speed indicator light activation: This
function allows you to select the engine
speed at which the indicator light will be
activated.
4. Engine speed indicator light deactivation: This function allows you to select the engine speed at
which the indicator light will be deactivated.
5. Engine speed indicator light brightness: This function allows you to adjust the brightness of the
indicator light to suit your preference.
NOTE:
_
• To make any settings in this mode, you have to cycle through all of its functions. However, if the
key is turned to “OFF” before completing the procedure, only the settings made before the
“SELECT” button was last pushed will be applied.
• In this mode, the multi-function display shows the current setting for each function (except the
engine speed indicator light activity function).
To adjust the display brightness
1. Turn the key to “OFF”.
2. Push and hold the “SELECT” button.
3. Turn the key to “ON”, and then, after five seconds, release the “SELECT” button.
4. Push the “RESET” button to select the desired display brightness level.
5. Push the “SELECT” button to confirm the selected display brightness level. The control mode
changes to the engine speed indicator light activity function.
To set the engine speed indicator light activity function
1. Push the “RESET” button to select one of the following indicator light activity settings:
a. The indicator light will stay on when activated. (This setting is selected when the indicator light
stays on.)
b. The indicator light will flash when activated. (This setting is selected when the indicator light
flashes four times per second.)
c. The indicator light is deactivated; in other words, it will not come on or flash. (This setting is
selected when the indicator light flashes once every two seconds.)
2. Push the “SELECT” button to confirm the selected indicator light activity. The control mode
changes to the engine speed indicator light activation function.
1
Engine speed indicator light
2
“SELECT” button
3
“RESET” button