Filter
Top Products
8 - 11
– +
ELEC
IGNITION SYSTEM
EAS00748
EAS00749
EAS00750
EAS00751
EAS00752
6. Crankshaft position sensor resistance
• Disconnect the crankshaft position sensor
coupler from the wire harness.
• Connect the pocket tester (
Ω
×
100) to the
crankshaft position sensor coupler as
shown.
Positive tester probe
→
gray
1
Negative tester probe
→
black
2
• Measure the crankshaft position sensor
resistance.
Crankshaft position sensor
resistance
248 ~ 372
Ω
at 20 °C (68 °F)
(between gray and black)
• Is the crankshaft position sensor OK?
YES
NO
Replace the
crankshaft position
sensor.
7. Main switch
• Check the main switch for continuity.
Refer to “CHECKING THE SWITCHES”.
• Is the main switch OK?
YES
NO
Replace the main
switch.
8. Engine stop switch
• Check the engine stop switch for continu-
ity.
Refer to “CHECKING THE SWITCHES”.
• Is the engine stop switch OK?
YES
NO
Replace the right
handlebar switch.
9. Neutral switch
• Check the neutral switch for continuity.
Refer to “CHECKING THE SWITCHES”.
• Is the neutral switch OK?
YES
NO
Replace the neutral
switch.
10.Sidestand switch
• Check the sidestand switch for continuity.
Refer to “CHECKING THE SWITCHES”.
• Is the sidestand switch OK?
YES
NO
Replace the side-
stand switch.