Yamaha YZF-R1PC Utility Trailer User Manual


 
7 - 27
FI
FUEL INJECTION SYSTEM
Fault code No. Er-1 Symptom No signal are received from the ECU.
Used diagnostic code No. --
Inspection operation item and probable cause Operation item and countermeasure Reinstatement
method
Open or short circuit in wiring harness and/or
sub lead.
Repair or replace if there is an open or short
circuit.
Between sensor coupler and ECU coupler
Yellow/Red - Yellow/Red
Black/White - Black/White
Reinstated by turn-
ing the main switch
ON.
Connected condition of connector
Inspect the coupler for any pins that may
have pulled out.
Check the locking condition of the coupler.
If there is a malfunction, repair it and connect it
securely.
Cylinder identification sensor coupler
Main wiring harness ECU coupler
Sub-wire harness coupler
Malfunction in meter Replace the meter.
Malfunction in ECU Replace the ECU.
Fault code No. Er-2 Symptom No signal are received from the ECU within the specified duration.
Used diagnostic code No. --
Inspection operation item and probable cause Operation item and countermeasure Reinstatement
method
Open or short circuit in wiring harness and/or
sub lead.
Repair or replace if there is an open or short
circuit.
Between sensor coupler and ECU coupler
Yellow/Red - Yellow/Red
Black/White - Black/White
Reinstated by turn-
ing the main switch
ON.
Connected condition of connector
Inspect the coupler for any pins that may
have pulled out.
Check the locking condition of the coupler.
If there is a malfunction, repair it and connect it
securely.
Cylinder identification sensor coupler
Main wiring harness ECU coupler
Sub-wire harness coupler
Malfunction in meter Replace the meter.
Malfunction in ECU Replace the ECU.
Fault code No. Er-3 Symptom Data from the ECU cannot be received correctly.
Used diagnostic code No. --
Inspection operation item and probable cause Operation item and countermeasure Reinstatement
method
Open or short circuit in wiring harness and/or
sub lead.
Repair or replace if there is an open or short
circuit.
Between sensor coupler and ECU coupler
Yellow/Red - Yellow/Red
Black/White - Black/White
Reinstated by turn-
ing the main switch
ON.
Connected condition of connector
Inspect the coupler for any pins that may
have pulled out.
Check the locking condition of the coupler.
If there is a malfunction, repair it and connect it
securely.
Cylinder identification sensor coupler
Main wiring harness ECU coupler
Sub-wire harness coupler
Malfunction in meter Replace the meter.
Malfunction in ECU Replace the ECU.