Filter
Top Products
4 - 75
CHAS
SWINGARM AND DRIVE CHAIN
6. Check:
• drive sprocket
• rear wheel sprocket
More than 1/4 tooth a wear → Replace the
drive chain sprockets as a set.
Bent teeth → Replace the drive chain
sprockets as a set.
b
Correct
1
Drive chain roller
2
Drive chain sprocket
EAS00711
INSTALLING THE SWINGARM
1. Lubricate:
• bearings
• spacers
• dust covers
• pivot shaft adjust bolt
1
• pivot shaft
NOTE:
_
Use the pivot shaft wrench
2
to tighten the
pivot adjust bolt to specification torque.
2. Install:
• relay arm
• connecting arms
NOTE:
_
Install the connecting arm front bolt
1
from the
left.
3. Install:
• rear shock absorber assembly
• rear wheel
Refer to “INSTALLING THE REAR SHOCK
ABSORBER ASSEMBLY” and “INSTALL-
ING THE REAR WHEEL”.
4. Adjust:
• drive chain slack
Refer to “ADJUSTING THE DRIVE CHAIN
SLACK” in chapter 3.
Pivot shaft wrench
YM-01471
T
R
.
.
Pivot shaft adjusting bolt
5 Nm (0.5 m · kg, 3.6 ft · lb)
Drive chain slack
40 ~ 50 mm (1.57 ~ 1.97 in)
T
R
.
.
45 Nm (4.5 m · kg, 33 ft · lb)
T
R
.
.
45 Nm (4.5 m · kg, 33 ft · lb)