Filter
Top Products
3 - 31
CHK
ADJ
ADJUSTING THE EXUP CABLES
EAS00101
ADJUSTING THE EXUP CABLES
1. Remove:
• bottom cowling
Refer to “COWLINGS”.
2. Remove:
• EXUP valve pulley cover
1
3. Check:
• EXUP system operation
▼▼▼▼ ▼ ▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Turn the main switch ON.
b. Check that the EXUP valve operates prop-
erly.
▲▲▲▲ ▲ ▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
4. Check:
• EXUP cable free play (at the EXUP valve
pulley)
a
Maximum EXUP cable free play
(at the EXUP valve pulley)
1.5 mm (0.059 in)
5. Adjust:
• EXUP cable free play
▼▼▼▼ ▼ ▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Loosen both locknuts
1
.
b. Insert a 4-mm long pin through the notch in
the EXUP valve pulley and into the hole in
the EXUP valve cover.
c. Turn both adjusting bolts
2
counterclock-
wise until there is no EXUP cable free play.
d. Turn both adjusting bolts 1/2 of a turn clock-
wise.
e. Tighten both locknuts and then remove the
pin.
▲▲▲▲ ▲ ▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
6. Install:
• EXUP valve pulley cover
T
R
.
.
EXUP valve pulley cover bolt
10 Nm (1.0 m · kg, 7.2 ft · lb)