Filter
Top Products
5 - 33
ENG
GENERATOR
REMOVING THE GENERATOR
1. Remove:
• generator rotor cover 1
NOTE:
@
Loosen each bolt 1/4 of a turn at a time, in
stages and in a crisscross pattern.
After all of the bolts are fully loosened, remove
them.
2. Remove:
• generator rotor bolt 1
• washer
NOTE:
@
While holding the generator rotor 2 with the
rotor holding tool 3, loosen the generator rotor
bolt.
3. Remove:
• generator rotor 1
(with the flywheel puller 2 and rotor holding
tool 3)
Rotor holding tool
YU-01235
Flywheel puller
YM-01080-A
INSTALLING THE GENERATOR
1. Apply:
• sealant
(onto the stator coil assembly lead grom-
met)
2. Install:
• generator rotor
• washer
• generator rotor bolt
WARNING
Always use a new generator rotor bolt.
Quick Gasket
®
ACC-11001-05-01