Filter
Top Products
3 - 30
CHK
ADJ
CHECKING THE CRANKCASE BREATHER HOSE/
CHECKING THE EXHAUST SYSTEM
3. Install:
• fuel tank
Refer to “FUEL TANK”.
• rider seat
Refer to “SEATS”.
EAS00099
CHECKING THE EXHAUST SYSTEM
The following procedure applies to all of the
exhaust pipes and gaskets.
1. Remove:
• radiator
Refer to “RADIATOR” in chapter 6.
2. Check:
• exhaust pipe 1
• exhaust valve pipe 2
• muffler 3
Cracks/damage → Replace.
• gasket 4
Exhaust gas leaks → Replace.
3. Check:
• tightening torque
NOTE:
• Install the spring 0 with its longer part a
positioned upward.
• Upper part “2” of the EXUP cable is attached
with the rubber boot cover.
• Install the EXUP cable in parallel without
twisting its upper and lower sides.
4. Install:
• radiator
Refer to “RADIATOR” in chapter 6.
T
R
.
.
Exhaust pipe nut
5
20 Nm (2.0 m · kg, 14 ft · lb)
Exhaust pipe and exhaust valve
pipe bolt
6
10 Nm (1.0 m · kg, 7.2 ft · lb)
Exhaust pipe and muffler bolt
7
20 Nm (2.0 m · kg, 14 ft · lb)
Exhaust valve pipe bracket bolt
8
20 Nm (2.0 m · kg, 14 ft · lb)
Muffler and muffler bracket bolt
9
38 Nm (3.8 m · kg, 27 ft · lb)