Filter
Top Products
4 - 54
CHAS
FRONT FORK
d. Press down on the spacer with the fork
spring compressor 1.
e. Pull up the rod puller and install the rod
holder 2 between the nut 3 and the
spacer 4.
NOTE:
_
Use the side of the rod holder that is marked
“B”.
f. Remove the rod puller and adapter.
g. Install the nut 1 and position it as specified
b.
h. Set the cap bolt distance c to specification.
i. Install the damper adjusting rod and cap
bolt, and then finger tighten the cap bolt.
j. Hold the cap bolt and tighten the nut to
specification.
k. Remove the rod holder and fork spring com-
pressor.
WARNING
@
• The fork spring is compressed.
• Always use a new cap bolt O-ring.
▲▲▲▲ ▲ ▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
Fork spring compressor
YM-01441
Rod holder
YM-01434
Distance
b
11 mm (0.43 in)
Distance
c
13 mm (0.51 in)
T
R
.
.
Nut
15 Nm (1.5 m · kg, 11 ft · lb)