Filter
Top Products
3 - 63
CHK
ADJ
CHECKING AND CHARGING THE BATTERY/
CHECKING THE FUSES
6. Install:
• battery
7. Connect:
• battery leads
(to the battery terminals)
CAUTION:
_
First, connect the positive battery lead
1
,
and then the negative battery lead
2
.
8. Check:
• battery terminals
Dirt → Clean with a wire brush.
Loose connection → Connect properly.
9. Lubricate:
• battery terminals
10.Install:
• rider seat
Refer to “SEATS”.
EAS00181
CHECKING THE FUSES
The following procedure applies to all of the
fuses.
CAUTION:
_
To avoid a short circuit, always set the
main switch to “OFF” when checking or
replacing a fuse.
1. Remove:
• rider seat
Refer to “SEATS”.
• front cowling inner panel (left)
Refer to “COWLINGS”.
2. Check:
• fuse
▼▼▼▼ ▼ ▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Connect the pocket tester to the fuse and
check the continuity.
NOTE:
_
Set the pocket tester selector to “Ω × 1”.
b. If the pocket tester indicates “∞”, replace
the fuse.
▲▲▲▲ ▲ ▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
Recommended lubricant
Dielectric grease
Pocket tester
YM-03112