4 - 15
CHAS
REAR WHEEL AND BRAKE DISC
2. Adjust:
• drive chain slack
Refer to “ADJUSTING THE DRIVE CHAIN
SLACK” in chapter 3.
3. Tighten:
• wheel axle nut
• brake caliper bolts
WARNING
_
Make sure the brake hose is routed prop-
erly.
CAUTION:
_
Do not loosen the wheel axle nut after tight-
ening it to the specified torque. If the
groove in the wheel axle nut is not aligned
with the cotter pin hole in the wheel axle,
tighten the nut further until they are
aligned.
Drive chain slack
40 ~ 50 mm (1.57 ~ 1.97 in)
T
R
.
.
150 Nm (15 m · kg, 108 ft · lb)
T
R
.
.
27 Nm (2.7 m · kg, 20 ft · lb)
EAS00575
ADJUSTING THE REAR WHEEL STATIC
BALANCE
NOTE:
_
• After replacing the tire, wheel or both, the
rear wheel static balance should be adjusted.
• Adjust the rear wheel static balance with the
brake disc and rear wheel drive hub
installed.
1. Adjust:
• rear wheel static balance
Refer to “ADJUSTING THE FRONT
WHEEL STATIC BALANCE”.