Filter
Top Products
Chapter 3: Standard Radar Operations 3-11
Changing the Targets
Display
Changing the Targets Display
The Pathfinder Plus Radar allows you to improve target visibility by changing
the following:
• Interference rejection
• Target expansion
• Target wakes
These parameters are accessed from the default soft key
TARGETS.
This section explains how to change these modes and describes the effect of
each mode. The current settings are shown at the right-hand end of the status
bar as shown in Figure 3-9.
Figure 3-9: Status Bar
➤
To change the settings of the target modes:
1. Press the
TARGETS default soft key.
The target option soft keys are displayed, with the current selections high-
lighted.
2. Press the appropriate soft key to toggle the required setting between OFF
and ON.
Note: If an option is not available for the current setting, its soft key label is
grey. When you press the key, the system beeps and the setting remains
OFF.
For the Wakes mode, press the
WAKES soft key to step the highlighted
selection through the wake options.
You can use the soft keys to change the settings of any or all the modes on
this display.
3. When the required options are highlighted, press
ENTER. The screen
returns to the default display with the new mode(s) in operation. The status
bar is updated to indicate which controls are switched on.
D3986-3
Wakes on Target Expansion on
Status Bar
Interference Rejection on
3nm
126°T
AUTO
WKS
FTC
EX
RC
GZ
IR
RR
1/2
H-UP
GST
TM TV3
D3642-2
TARGETS
INT REJ
OFF ON
EXPANSION
OFF ON
WAKES
OFF S M L
CLEAR
WAKES
WAKES
OFF S M L
81186_2.book Page 11 Monday, December 17, 2001 8:35 AM