Filter
Top Products
8-30
hsb
2
PLUS Series LCD Display
Data Conversion
Figure 8-18: NMEA Output Connector
Data Conversion
The
hsb
2
series displays convert some information across the communications
links as follows:
NMEA In to NMEA Out and SeaTalk
SeaTalk to NMEA Out
This enables data received by the display to be passed to other instruments. For
example, if you have a master and a repeater display, you only need to connect
NMEA In to the master display, which will pass the data to the repeater via
SeaTalk.
You can prevent NMEA heading data being bridged onto the Seatalk bus -
refer to Bridge NMEA Heading on page 7-8.
Note: To transfer NMEA data, or to convert the data, the display must be pow-
ered On.
Pin 2, white
Pin 5, screen
Pin 3, blue
Pin 4, not connected
*Pin 1 does not exist on this connector
NMEA OUT connector
NMEA OUT connector
Pin Pin name Function
2 NMEA_GND NMEA ground
3 NMEA_SIG NMEA data output
4 N/C N/C
5 CGND Screen
2
4
5
3
Rear of display
NMEA out
D4254_1
81186_2.book Page 30 Monday, December 17, 2001 8:35 AM