Filter
Top Products
Chapter 6: Further Chart Operations 6-5
Setting Alarms and
Timers
Setting Alarms and Timers
➤ To set up an alarm or timer:
1. Press the
ALARMS key. The Alarms Set Up menu is displayed, showing
the current settings (see Figure 6-2).
2. Use the trackpad to move the selection bar up or down the options. As each
line is highlighted, the soft key labels are updated to show the current set-
tings and controls.
Figure 6-2: Alarms Set Up List
3. Use the up or down soft keys to change the alarm setting. For example, for
the arrival alarm you can adjust the radius from the waypoint at which the
arrival alarm will be triggered.
The alarm distances can be set in the range 0.01 to 9.99 nm, in steps of
0.01nm. The timer is set in hours, minutes and seconds, and the alarm
clock in hours and minutes.
4. If required, press the
ALARM OFF ON soft key to toggle the alarm on or off.
If you turn an alarm off, its value is retained and will be used when you turn
the alarm on again.
Note: You can turn all the alarms and timers on and off, except for the Arrival
Alarm which is always on.
5. Press
ENTER to save the changes and clear the list.
ALARMS
SELECT ARRIVAL
ALARM RADIUS
ALARMS SET UP
OFF TRACK ALARM
ANCHOR ALARM
COUNTDOWN TIMER
ALARM CLOCK
ON
OFF
00:33:00
OFF
ARRIVAL ALARM
0.01nm
D4265-2
ALARM
OFF ON
81186_2.book Page 5 Monday, December 17, 2001 8:35 AM