Filter
Top Products
5-38
hsb
2
PLUS Series LCD Display
Using Tracks
➤ To receive the waypoint and route lists via
hsb
2
, you must set-up the transfer on
both display units - one unit will send waypoints, the other will receive them.
CAUTION:
Receiving waypoints from another
hsb
2
instrument overwrites any
existing waypoint and route lists.
1. Display the waypoint list as previously described, then press the
WAY-
POINT TRANSFER
soft key.
2. Press the soft key
SEND WPT LIST ON HSB or RECIEIVE WPTS FROM HSB. You
are prompted to confirm:
Press
NO to cancel the operation, then ENTER if you wish to close the way-
point list.
Press
YES to continue. The waypoint list is transmitted to/from the chart-
plotter from/to another instrument on
hsb
2
. While the data is being trans-
ferred the soft key changes to
STOP SENDING WAYPOINTS; when the
transfer is complete the soft key is re-displayed.
5.7 Using Tracks
The Track function is used to mark on-screen the trail that your vessel has
followed, as if it had left a visible fixed wake.
While the track is switched on it is recorded in the display unit’s memory. You
specify the interval at which track points are made and a line is drawn on-
screen between each point. Up to 4500 track points can be saved in total, in up
to 5 track files (each a maximum of 750 points). The current track remains on-
screen, even following a power off/on, until you clear the track.
Breaks in the track will be caused when any of the following occur for longer
than the specified track interval: the track is switched off then on; the position
fix is lost; the display unit is switched off.
To enable you to follow this track on your return voyage, the SmartRoute
function converts the track (or the last segment of a track with breaks) into a
route which is automatically reversed, see SmartRoute on page 5-42.
A track can be saved and retrieved for display at a later date. You can only
display one track at a time; you must clear a current track from the screen if
you want to display a saved track.
This section describes:
• Setting up a track, including how to specify the interval.
• Clearing the current track.
WAYPOINT
TRANSFER
81186_2.book Page 38 Monday, December 17, 2001 8:35 AM