Filter
Top Products
Chapter 2: Getting Started & Adjusting the Display 2-17
Offsetting the Center
➤ To move the enlarged area in view in the window:
1. Move the cursor over the edge of the zoom box in the original radar picture,
until the letters
ZMB appear under the cursor.
2. Press
ENTER to take control of the zoom box. The cursor shape changes to
a four-way arrow.
3. Use the trackpad to move the zoom box over the required area.
4. Press
ENTER again to drop the zoom box, update the enlarged version, and
return the cursor to normal control.
➤ To return to the normal display, press DISPLAY and then press the ZOOM soft
key to set the function
OFF.
Alternatively, you can press and hold
DISPLAY for 2 seconds. This also
removes any grouped data boxes.
Offsetting the Center
The radar picture is normally shown with your vessel at the center of the
display. However, you can move the center, so that your vessel is offset by up
to 66% of the radius, anywhere on the screen.
Note: You cannot offset the center when the radar display is set to the longest
range scale.
D3972-1
Zoom Box, indicating the
enlarged area. You can move this
using the context-sensitive cursor,
to change the image in the Zoom
Window
Zoom Box cursor text
Zoom Window, providing a
times 2 enlargement of the area
shown in the Zoom Box
T
AUTO
IR
3nm
RR
1/2
H-UP
126°T
RADAR ZOOM ( x2 )
CURSOR
BRG
033° R
RNG
1.78nm
ZMB
81186_2.book Page 17 Monday, December 17, 2001 8:35 AM