Filter
Top Products
3-18
hsb
2
PLUS Series LCD Display
Controlling VRM/EBL
Data Boxes
3. Alternatively, if you wish to move the floating VRM/EBL, press ENTER to
take control of it and move it using the trackpad.
Press
ENTER again to drop the VRM/EBL in its new position, or CLEAR
to abandon the operation and return the VRM/EBL to its previous posi-
tion.
➤ To unfloat a floating VRM/EBL using the keys:
1. Press
VRM/EBL to display the VRM/EBL soft keys.
2. Press the
FLOAT soft key.
3. Press the
UNF LOAT 1 soft key to unfloat VRM/EBL1, or the UNFLOAT 2 soft
key to unfloat VRM/EBL2.
The soft keys are cleared, and the VRM/EBL is repositioned with its ori-
gin at your vessel’s position.
Controlling VRM/EBL Data Boxes
➤ To move a VRM/EBL data box, using the context-sensitive cursor:
1. Move the cursor over the box until the letters
BOX are displayed, and press
ENTER to take cursor control of the box.
2. Use the trackpad to move the box to its new location, and press
ENTER to
drop it and return to normal cursor operation.
Each VRM/EBL data box is switched on and off with its associated VRM/
EBL. However, when one or both VRM/EBLs are active, you can turn the data
box(es) off at any time, if required.
➤ To control the VRM/EBL data boxes:
1. Press
VRM/EBL to display the VRM/EBL soft keys.
2. Press the
VRM/EBL DATABOX soft key to toggle the setting from OFF to ON or
from
ON to OFF.
Note: VRM/EBL data boxes are not affected by the setting of the
DATABOXES
soft key accessed using the SCREEN default soft key. This only controls the set
of data boxes available for integrated systems (see Chapter 2).
VRM/EBL
FLOAT 1
UNFLOAT 1
BOX
VRM/EBL
VRM/EBL
DATABOX
OFF ON
81186_2.book Page 18 Monday, December 17, 2001 8:35 AM