Filter
Top Products
Chapter 5: Standard Chart Operations 5-37
Transferring
Waypoints and
Routes
➤ To receive incoming waypoints on SeaTalk or NMEA:
1. To display the waypoint list press
MARKS followed by the WAYPOINT LIST
soft key.
Press the
WAYPOINT TRANSFER soft key.
2. Press the soft key
RECEIVE WPTS FROM ST/NMEA.
The soft key changes to
STOP RECEIVING WAYPOINTS.
When waypoints are transmitted by other equipment they are added to the
waypoint list on the chartplotter. Routes transmitted on NMEA are
appended to the route list.
3. To disable waypoint transfer, press the soft key
STOP RECEIVING WAY-
POINTS
.
Alternatively, press
ENTER, or CLEAR, twice to close the Waypoint List.
➤ To send the waypoint list on NMEA:
1. Display the waypoint list as previously described, then press the
WAY-
POINT TRANSFER
soft key.
2. Press the soft key
SEND WPT LIST ON NMEA.
The soft key changes to
STOP SENDING WAYPOINTS.
The waypoint and route lists are transmitted from the chartplotter to other
instruments on NMEA.
LOAD WPT/
RTE DATA
FROM CARD
SAVE WPT/
RTE DATA
TO CARD
CHECK
CARD IN
USER SLOT
USER CARD NOT PRESENT
SAVE FAILED
NO OR INCORRECT CARD
ENSURE USER CARD IS CORRECTLY
INSERTED IN THE LOWER SLOT
USER CARD MENU
MARKS
WAYPOINT
LIST
WAYPOINT
TRANSFER
WAYPOINT
TRANSFER
81186_2.book Page 37 Monday, December 17, 2001 8:35 AM