Filter
Top Products
190-00592-06 Rev. A
Garmin G1000 Pilot’s Guide for Diamond DA40/40F
385
AUTOMATIC FLIGHT CONTROL SYSTEM
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
LOC Approach Mode allows the autopilot to fly a LOC/ILS approach with a glideslope. When LOC Approach
Mode is armed, Glideslope Mode is also armed automatically. LOC captures are inhibited if the difference
between aircraft heading and localizer course exceeds 105°.
Selecting LOC Approach Mode:
1) Ensure a valid localizer frequency is tuned.
2) Ensure that LOC is the selected navigation source (use the CDI Softkey to cycle through navigation sources if
necessary).
3) Press the APR Key.
Or:
1) Ensure that GPS is the selected navigation source (use the CDI Softkey to cycle through navigation sources if
necessary).
2) Ensure a LOC/ILS approach is loaded into the active flight plan.
3) Ensure the corresponding LOC frequency is tuned.
4) Press the APR Key.
If the following occurs, the flight director reverts to Roll Hold Mode (wings rolled level):
•ApproachModeisactiveandaVectors-To-Finalisactivated
•ApproachModeisactiveandNavigationsourceismanuallyswitched
•During a LOC/ILS approach, GPS Navigation Mode is active and the FAF is crossedafter the automatic
navigation source switch from GPS to LOC
CHANGING THE SELECTED COURSE
The Selected Course is controlled using the CRS Knob (while in VOR, LOC, or OBS Mode). Pressing the
CWS Button and hand-flying the aircraft does not change the Selected Course while in Approach Mode.
The autopilot guides the aircraft back to the Selected Course (or GPS flight plan) when the CWS Button is
released.